A curing system that cannot reach the right heat range leaves crews guessing on job sites. So what temperature can the pulling device actually hit?
The digital temperature control on this unit adjusts up to 150 degrees Fahrenheit. This guide breaks down what that number actually means. It also covers why it matters and how to use it correctly on your next job.
Why The 150 Degree Ceiling Matters So Much
First, let’s talk about what this number actually controls. The pulling device runs on a flow-through dual-heater system.
This system warms both resin and hardener streams at the same time, rather than treating them separately. Because both streams heat together, the mix stays consistent from start to finish.
A 150-degree ceiling covers the heat range most resin systems actually need. Different resin formulations cure at different temperatures.
Because of this, having room to adjust matters more than a single fixed setting ever could. So, this range gives crews real flexibility across a wide variety of resin types.
Additionally, digital control means precision, not guesswork. A dial or manual adjustment can drift over time. However, digital settings hold steady throughout a job. This consistency protects cure quality from the first foot of liner to the last.
How This Temperature Range Supports Different Resin Types
The pulling device supports PipeCaster Pro resins directly. It also works with most 1 to 1 and 2 to 1 resin systems more broadly. These systems make up the majority of two-component resin used in pull in place work. So this compatibility covers most jobs a crew encounters.
Different resins call for different heat levels within that 150 degree range. Some formulations cure well at a lower setting. Others need heat closer to the maximum to activate properly. So checking your specific resin’s technical data sheet against this range confirms compatibility before you start mixing.
Curious whether your resin actually falls within this range? Reviewing the manufacturer’s recommended cure temperature against the unit’s 150 degree ceiling answers that question directly.
Full guaranteed compatibility applies specifically to IPP Solutions resin systems. This remains the most predictable pairing for the equipment.
For resin outside that lineup, confirming the temperature requirement matters. This step protects against a job that does not cure the way it should.
What Happens If A Resin Needs More Heat Than This
Occasionally, a specialty resin calls for cure temperatures beyond the standard range most equipment supports. The pulling device was built and tested around this specific temperature ceiling.
Because of this, resin requiring heat beyond 150 degrees falls outside what the system supports. Using it anyway risks an incomplete cure, regardless of mix ratio compatibility.
So before running an unfamiliar resin, checking both mix ratio and required cure temperature protects your job from costly rework.
A resin cured improperly due to insufficient heat rarely shows the problem immediately. Weeks later, that weak spot can become a real structural issue in the liner.
Additionally, cold weather conditions on site can affect how efficiently a system reaches its target temperature.
The pulling device addresses this directly. It maintains resin and hardener at proper application temperature even when the job site itself is not cooperating. This matters considerably for crews working through winter months across variable climates.
Getting The Most Out Of Your Temperature Control
Understanding the real ceiling on your equipment protects your cure quality. It also protects your project timeline.
The pulling device offers a 150-degree maximum through its digital temperature control. This gives crews enough range to handle most standard resin formulations confidently.
Combined with its dual heater system and quick connect design, this unit delivers real flexibility. Variable job conditions and resin types become far easier to manage.
If you are working with a resin outside our standard recommendations, reach out to IPP Solutions before your next job.
Our team can confirm whether your specific resin fits within this temperature range. That way, you start every job with real confidence instead of guesswork.
